Shot blasting machine in the work will inevitably appear oil spill situation. For example: Shot blasting machine engine rotary shaft, shot blasting machine engine oil leakage and a series of oil spills. So how can we deal with these sudden oil spills? Let's take a look at the common oil spill problems and measures.

1, shot blasting machine engine rotary shaft.

Reason and measures: If the shaft and hole wear each other, you can start the engine shaft and clutch handle shaft in the lathe cut out the seal ring groove, fitted with the corresponding size of the seal ring can be. If the aging of the decompression axis ring failure, should replace the new apron.

2, shot blasting machine plug oil plug( including tapered block, flat plug and process block)

Reasons and measures: If the oil plug is damaged or unacceptable, replace the new parts; if the screw hole damage, can increase the size of the screw hole, equipped with new oil block. If the cone-shaped wear, the tap can be used after tapping to flat plug, and then add the equipment used.

3, shot blasting machine engine oil leakage, switches, including water valves, fuel tank switches and gasoline switches.

Reasons and measures: If the ball valve wear or corrosion, should remove the ball valve and the hole between the rust, and select the appropriate ball instead. If the shock sealer and the fastening thread are damaged by the shot blasting machine, the fasteners and the replacement packing shall be repaired or replaced. If the cone joint surface is not tight, available fine valve sand and oil grinding.

4, shot blasting machine engine plane joint oil spill, plane joints, including paper pads, asbestos pad and cork sealed two planes. Wait.

Reason and measures: If the contact surface is uneven or contact surface with groove marks or burrs, should be based on the degree of uneven contact with the use of assorted file, fine sandpaper or oil mill polished, large machine available milling machine. In addition, the assembly of the gasket to be qualified, while cleaning, put down. If the bolt is loose, tighten the fixing bolts.

5, shot blasting machine engine pipe joints oil leakage, including conical joint and hollow bolt fittings.

Reason and measures: Cone joint pipe fittings, including pressure gauge at both ends, one end of the tubing, high pressure tubing at both ends and the fuel coarse filter to the pump end of the pipe joints, if the shot blasting machine engine high pressure tubing joints wear deformation or cracks, It can be sawed, for a good joint welding. If the low-pressure tubing joints damaged, can be cut off the trumpet, re-making bells. If the thread is damaged, repair or replace the new piece. Hollow bolt fittings include fuel crude, fine filter and fuel injection pump low pressure tubing fittings. If the gasket is damaged or uneven assembly, can be used for plastic gasket, or with assorted file trim, can also be used sandpaper polished, serious milling machine can be used to milling. If the pipe joints on the plane to produce drawing marks, can be used fine sandpaper or linoleum flattened joint assembly plane and gasket; if the mating surface with impurities, the assembly should pay attention to the body clean, joint fixing bolts should be tightened.

More reading:http://www.dx-blast.com/products